the left side inner and outer tie rods pulled apart at threads at jam nut. The threads approx 2 to three inches of threads were 100% rotted. The jam nut showed no sign of being loose. It did not UNTHREAD. No noise or any indication ever of an issue. It happened at 5:15 am. It was dark. I was at best going 1 mph in reverse. If t…
Read full complaint
the left side inner and outer tie rods pulled apart at threads at jam nut. The threads approx 2 to three inches of threads were 100% rotted. The jam nut showed no sign of being loose. It did not UNTHREAD. No noise or any indication ever of an issue. It happened at 5:15 am. It was dark. I was at best going 1 mph in reverse. If this had happened at road speeds the outcome could have been fatal for someone. For sure a lot of damage. I did not take a picture my bad. I did ask for the parts back but am 99%sure the part I got was not mine.it had a weld on it likely to move vehicle. The inner tie rod Was cut and looking like new, not a part exposed to the elements for 65k miles. I visually compared to other side. I will dissect it when I go to my friends shop. I could be wrong but doubtful. Call if questions. I had an extended warranty so they covered under that or a warranty/campaign? I was a NIASE AND NOW called ASE certified mechanic specializing in front end repair so…I would not knowingly drive cars that have a safety issue that could kill me or anyone. Safety first.
NHTSA ODI #11733180
Mileage unknown · Jul 3, 2025
Suspension
Rear leaf springs are flat and curving in opposite direction causing vehicle to bottom out with only 100 pounds in the truck bed. This is a potential safety issue as control problems to keep vehicle going straight.
NHTSA ODI #11671079
Mileage unknown · Jan 5, 2020
Power TrainService BrakesSuspension
1. VIBRATION FELT WHEN SLOWING DOWN. USUALLY BETWEEN 50 AND 20. BELOW 20 IT GOES AWAY. FEELS LIKE THE TIRES ARE OUT OF BALANCE BUT MY TRUCK HAS 8K MILES ON IT AND I HAVE FELT IT SINCE THE DAY I BOUGHT IT. 2. ALSO WHEN THE TRANSMISSION IS OUT OF GEAR AND CLUTCH IS OUT OR THE REAR END MAKES A SQUEAKING NOISE WHEN HITTING B…
Read full complaint
1. VIBRATION FELT WHEN SLOWING DOWN. USUALLY BETWEEN 50 AND 20. BELOW 20 IT GOES AWAY. FEELS LIKE THE TIRES ARE OUT OF BALANCE BUT MY TRUCK HAS 8K MILES ON IT AND I HAVE FELT IT SINCE THE DAY I BOUGHT IT. 2. ALSO WHEN THE TRANSMISSION IS OUT OF GEAR AND CLUTCH IS OUT OR THE REAR END MAKES A SQUEAKING NOISE WHEN HITTING BUMPS. 3. CLUTCH MAKES A NOISE WHEN RELEASING IT. 4. HIGH PITCH HUM IN 3RD, 4TH, 5TH AND 6TH WHEN MAINTAINING CONSISTENT SPEED. TOOK IT TO THE DEALER, THE DEALER WAS ABLE TO REPLICATE THE ISSUES WITH COMPARABLE TRUCK ON THEIR LOT AND BRUSHED IT OFF AS NORMAL.
NHTSA ODI #11297191
12 miles · Mar 4, 2019
Power TrainService BrakesSuspension
WHILE DRIVING THE TRUCK AT NORMAL SPEED 45+ MILES AND SLOWING DOWN VEHICLE HAS SEVERE VIBRATION FELT THROUGH OUT THE CAR. IT GETS WORST WHEN BRAKING SLOWLY AS IT COMES TO A STOP. ITS FELT ON THE STEERING WHEEL, BRAKE PEDAL, SEATS AS WELL AS THROUGH OUT THE ENTIRE TRUCK. TOOK IT TO THE DEALERSHIP AND THEY SAID IT'S NORMAL BUT I H…
Read full complaint
WHILE DRIVING THE TRUCK AT NORMAL SPEED 45+ MILES AND SLOWING DOWN VEHICLE HAS SEVERE VIBRATION FELT THROUGH OUT THE CAR. IT GETS WORST WHEN BRAKING SLOWLY AS IT COMES TO A STOP. ITS FELT ON THE STEERING WHEEL, BRAKE PEDAL, SEATS AS WELL AS THROUGH OUT THE ENTIRE TRUCK. TOOK IT TO THE DEALERSHIP AND THEY SAID IT'S NORMAL BUT I HAVE NEVER FELT THIS ON ANY TOYOTAS. I HAVE WORKED FOR TOYOTA FOR MANY YEARS AND TO HAVE THE DEALERSHIP TELLING ME THIS IS NORMAL IS JUST CRAZY. I BELIEVE IT'S COMING FROM THE DRIVE SHAFT OR REAR AXLE AREA BUT BY ME FIXING MY OWN TRUCK IS NOT GOING TO RESOLVE ANYTHING. THEREFORE I AM WRITING TO YOU TO SEE IF YOU CAN TRY TO RESOLVE THIS ISSUE. THIS ISSUE HAS BEEN GOING ON FROM THE DAY 1 OF THE PURCHASE AND GETTING WORSE. THANK YOU
Consequence: If the fuel pump fails, the engine can stall while driving, increasing the risk of a crash.
Remedy: Toyota will notify owners, and dealers will replace the fuel pump assembly with an improved one, free of charge. Owners of specific models were notified that remedy parts were available starting January 21, 2021. Owners of other models will be notified as remedy parts become available. Remedy parts should be available for all affected vehicles by late March 2021. Owners may contact Toyota customer service at 1-888-270-9371 or Lexus customer service at 1-800-255-3987. Note: This recall is an expansion of recall 20V-012. Toyota's number for this recall is 20TA02. Lexus' number for this recall is 20LA01.
Toyota Motor Engineering & Manufacturing (Toyota) recalled certain 2018-2019 4Runner, Highlander, Camry, Land Cruiser, Sequoia, Sienna, Tacoma and Tundra, and Lexus RC 300, RC 350, GS 350, GX 460, IS 300, LC 500, LS 500, LX 570, RX 350L, and 2019 Toyota Avalon and Corolla, and certain Lexus NX 300, and ES 350 vehicles on January 13, 2020. On March 4, 2020, Toyota expanded the recall to include certain 2014-2015 Toyota 4Runner and Land Cruiser, 2018 Avalon, Corolla, 2014 FJ Cruiser, 2017 Sienna and Lexus 2018 ES 350, 2018-2019 GS 300, 2013-2014 GS350, 2014-2015 GX 460, IS 350 and LX 570, 2014 IS F, 2018-2019 IS 350, LC 500H and LS 500H, 2013-2015 LS 460, 2015 NX 200T and RC350, 2017 RC 200T and RX 350. Toyota also removed the 2018-2019 Toyota 4Runner and Land Cruiser and 2018-2019 Lexus GX 460 and LX 570 and 2019 NX300 from inclusion in this recall. On March 19, 2020, Toyota expanded the recall to include 2015 Lexus GS350 vehicles. The low-pressure fuel pump inside the fuel tank may fail.
Consequence & remedy
Consequence: If the fuel pump fails, the engine can stall while driving, increasing the risk of a crash.
Remedy: Toyota will notify owners, and dealers will replace the fuel pump, free of charge. The recall began May 4, 2020. Owners may contact Toyota customer service at 1-888-270-9371 or Lexus customer service at 1-800-255-3987. Toyota's numbers for this recall are 20TB02 and 20TA02 for Toyota vehicles and 20LB01 and 20LA01 for Lexus vehicles.
Gulf States Toyota (GST) is recalling certain 2019 C-HR, 4Runner, Avalon, Avalon Hybrid, Camry, Camry Hybrid, Highlander, Land Cruiser, Prius, RAV4, Sequoia, Tacoma, Sienna, Tundra and Yaris vehicles. The text on the load capacity label may become illegible. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."
Consequence & remedy
Consequence: If the driver cannot read the label, they may unknowingly overload the vehicle, increasing the risk of a crash.
Remedy: GST will notify owners, and dealers will provide corrected load carrying capacity modification labels, free of charge. The recall began May 24, 2019. Owners may contact GST customer service at 1-800-444-1074. GST's number for this recall is 19R1.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018-2019 Toyota Tacoma vehicles. Improper machining of the brake master cylinder may result in internal damage of one of the seals, affecting brake performance.
Consequence & remedy
Consequence: Reduced brake performance can lengthen the distance needed to stop the vehicle, increasing the risk of a crash.
Remedy: Toyota will notify owners, and dealers will replace the brake master cylinder, free of charge. The recall began January 28, 2019. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's numbers for this recall are J16/J06.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
EA19001 · Electrical Overstress
Opened Apr 19, 2019 · Closed Sep 19, 2024
Status: closed (inferred from source dates) · Air Bags: Air Bag/restraint Control Module
The Office of Defects Investigation (ODI) opened this investigation to determine if the failure of airbags to deploy during severe crashes, in certain vehicles, was the result of a safety related defect. During the investigation a complex failure was studied that can result in non-deployment of subject vehicle air bags and other restraint system devices in severe crash events. The subject vehicles may be equipped with an airbag control unit (ACU) for the supplemental restraint system (SRS) Electronic Control Unit (ECU) manufactured by ZF-TRW. The ECU receives signals from crash sensors mounted in the vehicle and deploys the vehicle air bags and seat belt pretensioners in accordance with manufacturer design specifications. The ECU in the subject vehicles contains a model DS84 application-specific integrated circuit (ASIC) which controls the communication of the crash sensor signal, firing commands (i.e., when to deploy the airbag(s) and/or pretensioners), and fault information (e.g., diagnostic trouble codes). In September 2016, FCA announced recall 16V-668 for certain model year (MY) 2010 to 2014 Chrysler, Dodge and Jeep products manufactured with the subject ZF-TRW ACU. In this recall, FCA discussed an EOS condition that resulted in a failure of the subject DS84 ASIC, which caused air bag non-deployment. FCA noted that the defect condition had only been observed in vehicles equipped with sensor harnessing routed across the front of the vehicle. Other FCA vehicles that also used the subject ACU, but were not equipped with cross-car harnessing, had not experienced EOS failures, despite similar time in service. During the course of this investigation, ODI sent two separate Information Request (IR) letters to six vehicle manufactures (including FCA, Hyundai, Honda, Kia, Mitsubishi, and Toyota) and one IR letter to ZF-TRW. These IR letters resulted in ODI receiving comprehensive data from these manufacturers and suppliers. Studies of this data found that the DS84 ASIC does not have sufficient protection against negative electrical transients or electrical overstress (“EOS”) that can be generated in certain severe crashes. An electrical transient occurs when the electrical power supplied to a circuit changes momentarily over a short duration of time. In these severe crash cases, the crash sensors and other powered wiring can be damaged and short circuited so as to create a negative electrical transient of sufficient intensity and duration (that are outside the vehicle manufacturer's specification) to damage the ASIC before the restraint device deployment signal is received by the SRS ECU. This damaged signal can lead to incomplete or nondeployment of the air bags and/or pretensioners. Airbag non-deployment and/or lack of pretensioner operation can increase the risk or severity of injury in a crash.A total of 8 fatalities and 14 injuries were associated with known EOS events. The common element in all investigated manufacturers vehicles is the SRS ECU containing a DS84 ASIC manufactured by ZF-TRW. The risk associated with the ASIC is equally shared among all OEMS involved in the investigation. The actual real-world risk can be mitigated by other factors which were assessed by ODI during this investigation. The first mitigating factor involves protections built into the ACU design which protect the DS84 ASIC from damage. There are multiple strategies and levels of protection employed by different OEMs that provide effective EOS mitigation. The two most common strategies at the ACU level are circuit protection diodes on the remote senor signal lines, and current limiting resistors that protect critical components. The second mitigating factor is found at the vehicle level and involves the location and routing of the wires leading from the crash sensors to the SRS ECU. If the wires are well protected in a crash and are not routed with other power wires carrying large currents, the risk for an EOS event is significantly reduced or eliminated. These design specific factors combine to produce a spectrum of risk for the vehicles equipped with ACUs using the DS84 ASIC. Given the many of years of field exposure, it is possible to divide the subject population into two groups; vehicles which have experienced EOS events, and vehicles which have not experienced EOS field events. Four of the six OEMs involved in this investigation have experienced EOS field events on at least one of their models equipped with a DS84 ASIC. All vehicle models (including the Toyota models identified in the Failure Report Summary of the opening resume for this investigation) with field events have been recalled. In an abundance of caution, ODI kept this investigation open five years to monitor field performance and did not identify any field events on vehicles not included in existing safety recalls. Given the spectrum of risk identified in this investigation and that all vehicles with a demonstrated unreasonable risk have been recalled, ODI is closing this investigation. ODI is closing this investigation with the following manufacturer safety recalls: 16V-668, 18E-043, 18V-137, 18V-363, and 20V-024. With the recall actions taken by the subject vehicle and equipment manufacturers, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exists on other model or model year vehicles outside of the recall scopes. The agency reserves the right to take further action if warranted by the circumstances.
2019 Toyota Tacoma Problems, Complaints & Recalls | Skip That Year
Illustration